Nozzle Marker for Enders
Description
This idea came from me swapping plenty of nozzles lately but at one point not remembering which one was installed and me setting up my slicer wrong. So my print failed due to the wrong nozzle used. The marker snaps nicely into the extruded frame profiles, the best way to take take them out is to use an Allen key and lever them out from below. The marker I used to highlight the numbers was a Sharpie brand pen that has the tendency to run between the layer lines and smear a good bit - if you find a better way or marker brand please leave a note in the comments.
Statistics
Likes
0
Downloads
0