Polycom IP650 and others Wallmount
Description
This is a wallmount for a Polycom IP 650. It will probably fit 550 and others too. The model is already hollowed out, so no infill. It print upright without supports. There are screw holes in the "claws" where you can put an M3 ~8mm short screw if you feel it's not sturdy enough. Installation: 1. Put the bracket on the wall and mark the holes for the screws 2. Put the screws in the wall leaving around half an inch 3. Put the phone on the mount 4. (Optional) Put M3 screws in the holes, they will thread themself in the phone 5. Pass the cables in the holes and plug them in 5. Slide the mount on the screws
Statistics
Likes
0
Downloads
0