TBS Immortal T-Crossfire Nano Holder For TBS Source One V5
Description
This is a holder for your immortal T antenna (new version), and crossfire nano receiver. It is made to fit the tbs source one v5 frame, mounted in the front just under the camera. It is a really tight fit, but that is exactly the way I wanted it. Print the parts, mount the antenna in the bottom base then super glue the top base on. Afterwards you simply coil the antenna wire a few times and plug into the nano receiver. Then you'll take the nano receiver and place it in the cutoff in the back of the bottom mount. Take your heat shrink included with your receiver and lightly shrink it on the receiver and bottom mount, remember this is a 3d printed part and will melt. I made a little cut out going out of the back for the wires but mine didn't need it. I printed mine out of nylon, but use whatever material you like. Just remember carbon fiber is supposed to be conductive. No supports are needed, 1mm layer height.
Statistics
Likes
0
Downloads
0