Dial Indicator Holder for Ender 2 V2 Neo
Description
I was having issues and I wanted a more stable way to measure the imperfections in the bed, then I remembered I had dial indicators! :) Clips on to extruder- No modifications... I'm not 100% certain, but I think most inexpensive dial indicator mounts are the same size. I used a M5 cap screw with a Nylon Insert Jam Nut to hold it securely. Pros?? - Creates a way to bed level (I believe) much better than using the paper method. - It holds the dial indicator securely, but you'll have to watch it when making measurements. Cons?? - It can't reach the rear of the bed. It will get you approximately 2/3 of the way to the back. (I'm going to try to make another on that can hang on the side of the extruder shroud...) - The clip that goes over the back of the extruder head covers over the screw in the back. Instructions for use: - You'll need to raise your Z to about 50mm - Attach the indicator and slowly lower the indicator onto the print surface. -Position it over each of the 4 adjustment screws (as best as you can, given the limited Y-Axis movement) and adjust the bed leveling screws to make them equal. - Then run the BT Touch Bed Leveling program. - Then set your nozzle offset. Hopefully this helps you as much as it did me!
Statistics
Likes
0
Downloads
0