Fokoos Odin F5 Kid Shield
Description
If you have kids or unwanted ponderers, like I do this is the solution to the unwanted buttons presses. I took a 15 min nap about 30hrs into a print to find my print had stoped at 80% due to someone meddling with my Odin F5 printer. I came into my office to see the printer stopped, initially excited the print was done, only to find a partial print and guilty faces. I proceeded to shake the house with "NOOOOOO . . . DAAAAMIT!" After much contemplation about where to relocate the printer I found a shield was my best option. I printed the shield on my Fokoos Odin-F5 in two pieces due to the print bed size, and glued the two halves together. You will need a small piece of plexi glass for the view port. I used a small piece of broken drum shield, but there is enough clearance even packing tape would do. The shell is 8mm thick with an inset of 5.5mm for the glass. You should be able to put just about anything in the recess. Hope this saves someone else's print in the future.
Statistics
Likes
0
Downloads
1