hairband embroidery hoop
Description
Please resize in slicer to 50% the file exported too big. The diameter should be 10cm. This embroidery hoop has been designed to be used with a standard hair elastic. It can be used with rubber bands too, just adjust the sizing to match the stretch of your elastic. Print with the largest overhang on the bed and prints without supports. I print mine at 80% infill to make them nice and strong, but I think that is overkill. You can print them at low resolution too , so they should print in under 2 hours. this one was printed on a sidewinder x1 see through red PLA
Statistics
Likes
0
Downloads
0