Lynx - Footlock Extender
Description
A footlock extender for the Lynx, similar to the one I made for the Patton. The footlock on the Lynx is pretty nice and functions decently but it's also a bit small and angled in such a way that you lose a lot of support around your toes. This extender adds width (making the footlock 6.5cm wide in total) and remains consistently wide across the whole length from front to back, it also has 10mm of added cushioning below the footlock for added softness. I have created 3 different design variants which are purely aesthetic, see screenshot. Print in <strong>TPU95A</strong>, use 2 walls and 12% Gyroid Infill, print it laying flat on the side with the hollow part pointing upwards. The STL files are for the left side, just mirror them to get the right side. <strong>Installation:</strong> While these extenders are designed to be friction fit, due to the many different angles on the LeaperKim footlocks friction fitting might not be enough to hold them in place over time, for peace of mind I recommend attaching two small pieces of double sided tape on the inside at the top, see photo.
Statistics
Likes
0
Downloads
0