Meta Quest 3 touch plus saber/racket handle V1
Description
This is the first version of a touch plus handle primarily designed for playing Beat Saber, but i found it works really well as a racket handle (using it on Racket Club), it give a better feeling of your racket's position. You have to slide the wrist wrap first through the hole in the model, then the controller. This is when, depending on your filament's plasticity, it might break. That's why I recommend using a not too rigid filament (for example the transparent one I used is a little bit too rigid so it might break in time). To make the controller hold, I had to cut the wrist wrap in two, pass it through the hole along the model, and tighten it at the bottom of the handle (see pictures). But if you don't want to cut the wrist wrap, you might be able to make a knot on it, and attach another string that will hold the controller. Use a raft to ensure stability during printing. the handle is not perfectly right, so inside Beat Saber you might want to offset the controller a bit in the options (z position minus 1.1 cm, x rotation minus 1 degree)
Statistics
Likes
0
Downloads
0