Zhiyun crane 4 additional grip
Description
Hi all ! I did not find the sponge part on the factory side grip of the Zhiyun Crane 4 gimbal to be suitable. It will get damaged and dirty in the long run. It's not that comfortable. I edited this grip for that. You just have to put it on the sponge and fix it with two screws at the bottom. Unfortunately, the height cannot be adjusted when the handle is installed, but it still fits in the bag when fully extended. I used allen head screws with a diameter of 3 millimeters. For the light handle, I cut off the heads of the screws and cut a screw head into it. It is difficult to properly remove the plastic residue of the support from inside the heavy grip. For this purpose, I 3D printed a cone, glued sandpaper to it and pulled it onto the tip of a screwdriver to sand the heavy handle from the inside. That's why I designed the cap separately for the light grip, which has to be glued in place afterwards. 100% filling and high wall thickness are recommended to avoid breakage.
Statistics
Likes
0
Downloads
0