T4R desk clock
Description
uses a deans connector an a slightly modified clock from a lot of toyota models to make a desk clock. this is a work in progress and i may make it look fancier later but this is simple for now and prints quick with very little supports i will add my make to give you an idea of the modifications but its basically sanding to make a tight fit and a piece of 3m take on the back cover. if you remix this please give me a shout out that's all i ask parts needed male deans connector female deans connector attached to a 12 household power supply 4 8mm long m3 screws small piece of 3m double side tape one toyota clock sand paper for fitting i only wired battery and acc to positive and left the illumination alone then wire the ground of course. then i cut the old plug part off the clock
Statistics
Likes
0
Downloads
0