60percent (HHKB layout) Keyboard
Description
The **60percent** is a 60% keyboard with Bluetooth (BLE) powered by ZMK. Below, you can find a full list of required parts you will need to complete this keyboard. On my [Github](https://github.com/inverseTrig/60percent-zmk-config) you will find links that I personally used to purchase these parts. I am not affiliated with any of the links. If you're new to [handwiring](https://geekhack.org/index.php?topic=87689.0) a keyboard, it really isn't too bad, trust me! I hope this keyboard can start you on a journey to finding a keyboard that perfectly fits your needs. Are you looking for a [macropad](https://www.thingiverse.com/thing:6497724)? **Required Parts** | Part | Qty | Description | | ------------------------------------------------------------------------------------------ | ----- | -------------------------------------------------------------------------------- | | Challenger 840 BLE | 1 | Micro controller board with Bluetooth LE | | MX-style switches of your choosing | 60 | I used Outemu Lemon/Limes. | | 1N4148 Diodes | 60 | You need these for handwiring | | Keycaps | 1 set | You will need a 7u spacebar in the set | | Cherry stabilizers | 1 set | Requires 1 x 7u and 2 x 2u | | Wires | - | I used wrapping wires | | M2 x 6mm hex female-to-female brass standoff (spacer) | 5 | This is what supports/holds down the plate and the case together | | M2 x 12mm countersunk screws | 2 | Case-side that goes with the brass standoff | | M2 x 10mm countersunk screws | 3 | Case-side that goes with the brass standoff | | M2 x 6mm flat top screws | 5 | Plate-side that goes with the brass standoff | | M2 x 6mm countersunk screws | 4 | Holds the MCU down | | M2 hex nut | 4 | Holds the MCU down | | 3.7v LiPo Battery | 1 | You'll have to source this locally, as batteries aren't shipped overseas usually | | JST 2.0 PH Connector | 1 | Required if the battery doesn't come with compatible connection |
Statistics
Likes
0
Downloads
0