31 Tooth to 11 tooth Drive Gear for Robot Vacuum
Description
I built this gear to replace the 31 Tooth to 11 Tooth Gear in my Shark Robot Vacuum. I recommend a filament printer as I have been told, but not verified that it would hold better than a resin-printed part. The filament-printed gear has held up as of writing and uploading this model has lasted a week and continues to work. The bottom of the 31 Tooth Gear will need a small 7/32in or 5.5mm hole drilled in the bottom for the casing to close entirely.
Statistics
Likes
0
Downloads
0