Foxbody Mustang heater knob
Description
this is a quick remix of the wonder design by @qkpony. All I did is remove the text. if you would like one with custom text please let me know and I would happily do that for ya Note: I did print this and it prints amazing, I did use ironing though that is not necessary. I would also recommend blocking supports on the small part that connects to the heater control (the shaft thing), this is not 100% needed but its easier than the clean up needed afterward. I did print this in both PETG and PLA+ but I would recommend PETG for obvious reasons pertaining to heat inside the vehicle
Statistics
Likes
0
Downloads
0