DJI Pocket 2 waterproof case
Description
DJI Pocket 2 3D Printed waterproof case Be sure to watch the video. https://www.youtube.com/watch?v=Dpu3QfSci3Y Before placing it in the waterproof case, activate the waterproof case mode in the camera menu. In this mode, the camera is constantly looking forward at 55 degrees. No selfie mode. The right button turns the camera on and off and switches between video, photo and slow motion modes. The camera is not capable of circular movement, it dampens the movement. Making a waterproof case requires advanced DIY knowledge to understand why you are doing it. I made the model available only after I had assembled it and tested its reliability. Everyone uses the waterproof case at their own risk. Be sure to test it without a camera before use. After each use, shake off the water from the case, because water may remain between the screw threads. O-ring diameter: 4 mm Outer diameter: 84.5 mm Inner diameter: 76.5 mm O-ring material: soft TPU I also printed the O-ring and the button membrane from TPU. It turned out perfect. But the O-ring can also be bought or made to measure at companies dealing with this. When everything is there and the O-ring is glued in place, apply a very small amount of silicone grease to the outer part. It will be easier to loosen the cover. Laser-cut plexiglas can be bought inexpensively in many places in decoration shops. I also bought it for 4 euros. Plexiglass (disc) size: 4 mm thick and 80 mm in diameter Display plexiglass size: 2 mm thick and 27x25 mm Plexiglas is more sensitive to scratches than glass, but it is much easier to buy plexiglass cut to size and glue it together with plastic. When using and cleaning it, take care not to scratch it. If not in use, put the protector on it. If the glue is slightly visible on the edges of the plexiglass during gluing, do not try to wipe it off, as it will corrode the surface. It won't show up on the camera anyway. Before gluing, wipe the plexiglass clean and degrease it. Thx.
Statistics
Likes
0
Downloads
0