Quadrilla Spiral Reservoir
Description
Totally a work in progress....I made the original design over Christmas, but I did it in Inventor because I'm much more familiar with it. Honestly, Fusion is a pain. No 3D helix option! Worse, their hack of create a coil and project it into a 3d sketch induces a twist into the geometry swept across it! If the fusion export didn't "heal" the stl, I suspect it will need healing. Ridiculous. I may just give up and post the IPT instead and the stl generated from the IPT! The one change I made is my brother added some clay to the exit from the quadrilla block at the top of the ramp to direct the marbles down the ramp. I put a small angle of plastic up there which should reflect the balls into the ramp downwards. Other than that, this is just a straight redo in fusion.
Statistics
Likes
0
Downloads
0