NewBeeDrone 65mm Cockroach Brushed TPU kit
Description
This kit holds two prints that are useful for building older-style tinywhoops. * A mount for SMD (063) LEDs and circuit board for the LEDs and resistors. This allows you to mount LEDs on transparent Cockroach frames so that each prop guard glows with the color of the LED. I use it for orientation. * A cap for 3-pin dupont connector - used for flashing Silverware boards, like the AlienWhoop ZER0. Needed to complete: * 4x4 hole piece of a protoboard, cut to 11mm x 11mm * 2 red SMD LEDs, 2 green SMD LEDs all 0603 size * 4 SMD 0603 resistors, 50-100 Ohm depending on LED nominal voltage drop * 30AWG wire The LED mount and PCB goes between the FC and the battery slot.
Statistics
Likes
0
Downloads
0