75mm Dust Collection - Corner Floor Sweep
Description
Hello, Again!! This bad boy is part of my 75mm dust collector suite, a rugged floor sweep! This is 196mm by 196mm triangular profile and 48mm high. Two can fit on a 200x200 print bed if printed upside down, and four could be printed if it's laid on it's side. No supports! It's a 4.5hr print on my ANYCUBIC Kobra Neo, but 3 hours on my ELEGOO Neptune 4 Max. Only uses 153g of filament! I used 4 wall loops, three shell layers top and bottom, 10% adaptive cubic in-fill, and 0.32 layer height. It's a bit of a chunker, given that it's a piece of shop equipment that's BOUND to be abused, but hey, if it's broken it can be replaced. Check out my other items in the "75mm Dust Collector" series! --- Pipes --- Blast Gates --- Standoffs Steal, sell, print, remix, enjoy! I just want to contribute to the community that's given me so very much. :) Greetings from Newfoundland, Canada!
Statistics
Likes
0
Downloads
1