Lenovo Legion Go - comfortable controller grip replacement (left)
Description
It's an attempt to design a comforable replacement of original controller for legion go. After disassembling it, I noticed that front faceplate can be changed separately (it has originally a sharp edge in the palm area). Lenovo applies fillet ~2mm where spacing between PC allows a fillet with radius 7,5mm which should theoretically spread the load on the hand. This is the result. Mod is really simple, after printing it faceplate can be changed easily - only a couple of screws needs to be disassembled, thre are no tricky glued/welded edges. Mod is fully reversible. Work is not finished, it needs a small decorative ring addon to fill the small gap around the analog. Also second controller is not designed yet. I'm not sure if I will have energy to make one. Process to make one was a little bit time consuming. I used a paper scanner to create a canvas from different angles and then try to recreate the original design.At the end I applied a fillet in the palm area. Depends on the printer it can fit better or worse, small trimming may be nescessary. I think printhead 0,4mm is too large and I am not entirely happy with the result. 0,3mm Would be much better for the small parts where screws goes but I have only 0,4 printheads :(. I am happy to share the fusion360 design with somebody who would like to continue my work. Selling design or printed part is not allowed. Post where I posted design steps: https://www.reddit.com/r/LegionGo/comments/1auuob1/legion_go_attempt_to_enhance_the_comfort_of_the/ Enjoy
Statistics
Likes
0
Downloads
1