Fully 3D Printed Balisong
Description
This is a balisong that i have designed. Just print the two files that say READY. The tolerances are fairly tight so make sure your printer is well maintained. Also i suggest waiting for your bed to cool down before removing the print, or else it can warp it and it wont fit properly. FYI: If you drop it on hard floor to much the pins will fall out. I recommend putting a small amount of glue on the side or on the top of the pin, be careful to not glue the blade to the pin. Comment any suggestions/changes you want to see.
Statistics
Likes
0
Downloads
1