Blade Fuse Holder with snap lid
Description
<p>Inspired by this design, <a href="https://www.thingiverse.com/thing:3562425/"> car fuse holder</a>.</p> I created a fuse holder with a swivel lid that uses a piece of filament as the hinge. I needed something that would be taped down inside my diy solar generator that could carry spare fuses without worrying about opening and spilling them everywhere so I created this with a snap fit cover. The cover clips in strong enough so it wont open unless lifted from the handle. The measurements for this are based on a blade fuse kit I found on aliexpress, the inside of the case is angled so the fuse contacts are guided into the smaller slot. There should be enough tollerance for most blade fuses to fit. I printed everything at 0.2mm layer height in spectrum matte black pla.
Statistics
Likes
0
Downloads
0