TPU Battery Case for 1300mAh CNHL Lipo
Description
I've been tinkering with a race quad lately, and I quickly realized how much abuse that a bottom mounted lipo battery must endure. Even just a tumble through the weeds has left scrapes, cuts and dings on my 6s lipo batteries. It's just a matter of time before a puncture happens and the fire is let out. I designed this simple case, **built specifically for the 1300mAh CNHL** lipo to hopefully negate any harmful battery damage due to collisions or tumbles when crashing. It also doubles as landing feet to stabilize the quad during take off and landing. **You will need a spare grippy battery mat that's 30mm (or less) wide to effectively use this holder.** The TPU alone isn't grippy enough to keep the battery snug. There is a 30mm wide recessed channel cut into the top side of the case for an adhesive battery mat to be attached. If the fit seems too tight for your battery, **don't continue forcing the battery into the case** it may become jammed in there and very difficult to remove. There is a relief hole cut in the opposite end of the case to gently push the battery back out **(never pull on the leads)**, but this should not be an issue. Check your print settings/calibration and re-print.
Statistics
Likes
0
Downloads
1