Parts Bin for PWACCS Pressure Washer Accessory Holder
Description
I recently got a PWACCS Pressure Washer Gun Holder from Amazon to neatly store accessory parts for my pressure washing systems. However, all the available holders, including this one, have one drawback in that they don't have provisions to store all the small parts like jets and o rings and special tools. The PWACCS unit has a fairly large rectangular opening on its front side so I designed a drawer to fit into the cavity. To latch the drawer in place, I added compartments to captivate 10mm x 20mm x 2 to 5mm thick rare earth magnets in the bottom and then glued mating magnets between the ribs from the rear of the main unit using the magnets in the drawer to locate and hold these magnets while the glue dried. I have had great success using Fix-all gel super glue, that I get at Dollar Tree, to glue both PLA and PETG. These parts don't require either adhesion or support and take half a day to print. I have pretty much switched to PETG, but I think that PLA would work as well as long as it is not exposed to too much heat. I think that this is a nice accessory and makes a good product even more useful.
Statistics
Likes
0
Downloads
0