Roland SP404MKII Stand
Description
There's definitely a shortage of free stand options out there for this device. If you find any cool ones, let me know in the comments. I made a remix of the original design to lengthen the spikes by almost an inch, so the angle of the SP-404MKII would be higher. I also put a 20 degree angle on the base so it sits more flush with the table. You don't need to add any rubber feet to it, but you can if you want. Additionally, I removed some of the center material to speed up the print and save some filament. I think the slits in it look cooler than the text. This item is also more safety conscious because it won't stand on its own, unless it's inserted into the sampler. I used PETG, but I'm sure it will print just fine and be strong enough with PLA. You can save time by printing it low resolution. I used 0.30mm and 30% infill. Definitely add supports because the ends of the spikes don't touch the print bed, but the center section with the slits doesn't need support to print correctly. Please understand that I am not a 3D designer. I tweaked this using TinkerCAD website. So I'm sure it can be optimized even further. Enjoy!
Statistics
Likes
0
Downloads
0