Heavy Duty Guitar Wall Mount
Description
idden Screw Design. Fix bracket to wall then slot mount over - MUST print bracket laying down so layer grain runs the length or bracket - MUST print the mount standing up. If not, I can not guarantee the strength of the part. - 0.2 layer height - Minimum of 3 wall thickness - 20% Gyroid infill - The guitar mount works great in quality PLA, but stronger materials would be beneficial. - See the image attached for hole dimensions. I used M4 Screw. Approx 40mm in length - Use suitable wall fixings to avoid failure.
Statistics
Likes
167
Downloads
552