Flashpoint boardgame insert

Description

Insert for the Flashpoint boardgame, with the Urban Structures expansion - all in the core box. You only need one of the 'cards' trays, and don't need the 'Padding_SPARE' at all, however printing the spare and a second card tray will completely fill the box and stop anything moving around (I intend to use some foamboard to do the same, rather than waste filament). The trays are 25mm tall and thus fill the box with both the core and Urban Structures boards inside with no lid lift. Adding another expansion is possible, with lid lift appropriate to the thickness of the additional board, but there's space with the extra cards & the padding tray to fit any extra tokens. Note - the trays are *MEANT* to have small slots in the bottom - as the tokens and figure bases are 25mm round, they fill the vertical space, and there's no room for a bottom layer under them, however being round, it's only a tiny section that doesnt have a bottom and the tokens/figures do not actually protrude at all. All designed on Tinkercad, which is plenty good enough to do the job. Photos show my original version (my setup tray broke slightly due to some rubbish pink filament I was trying to use up, but not enough to warrant reprinting it) and I've slightly resized the trays so that the Figures/Play Tokens/Setup Tokens are all half the width of the cards tray, just to fit more nicely, and reduced the cards width by a 1mm so it's not quite as snug a fit widthways - changes that will benefit the next print run, but not worth me actually reprinting them for.

Statistics

Category

Tags