Sprite Cable Riser
Description
After installing a Creality Sprite Extruder Direct Drive Dual Gear Extruder SE Upgrade Kit on my Ender 3 Pro I found the cable management to be problematic. If the cable was routed to either side it (the cable) would hit the gantry support limiting the x axis movement. Routing the cable over the top solved this, but when tied down the extruder gear would rub on the cable. So I went to tinkercad and made this riser to lift the cable above the gear, tied it down and problem solved. The distance in the third picture (yellow arrows) wasn't there prior.
Statistics
Likes
0
Downloads
0