DarwinFpv TinyApe Runcam Thumb Pro + BetaFpv 2s 450mah Mount
Description
Notes: . Rotate before printing, the down-plate is flat on the bed . I tried with & without support, It prints better without support . Little bit of cleaning strings required after the print This is a Runcam Thumb Pro-W 4K holder + a battery holder for DarwinFpv TinyApe Freestyle 2.5 inch FPV Drone: DarwinFPV TinyApe Freestyle 2.5 Battery: Lava 2S 450mah Camera: RunCam Thumb Pro With the original camera holder I used the same standoff screws in the front and in the back 2.5mm. zip tie with the lock under the frame Then I reduced the power cable length (you might not have the same length as I saw in reviews and pictures) so I can load the battery from the back and just plug the power You can also plug the battery from the front with the power cable facing the front, but then I needed to manage the power cables to avoid the risk of touching the propellers, which I could manage by using the battery strap.
Statistics
Likes
0
Downloads
0