RCWL-0516
Description
This case holds a RCWL-0516 microwave sensor and an ESP8266 Node MCU development board and allows the case to be held by the 5v AC adaptor that powers the MCU. It is simple to print and modifiable for the project. Almost any small screws can hold to lid on, I normally just use something out of my junk box. This is a version that hangs from a normal wall plug, I bought some shorty micro usb cables from amazon to make it neater. As bought the RCWL-0516 is very sensitive and in a 600 sq ft cabin it picks up when I roll over in my sleep, from the next room. I had to put a resistor on the sensor at the R-GN pads on the back of it. I think it was around 470k ohms.
Statistics
Likes
0
Downloads
0