Door support (anti-sag) for 3D printer enclosure

Description

I Built Schlem'S 3D Printer Enclosure (Having Long Since Been Banished To The Most Remote Corner Of My Garage By She-Who... You Know...). I Found That The Door Sagged By About 3/4 Inch, So I Created This Simple Support Bracket. I Glued It Onto The Outside Of The Door Using Cyanoacrylate (Superglue). As With All My Cyanoacrylate On Acrylic, I Needed To Clamp It While Drying (Using Spring Clamps). Some Of The Acrylic I Used Was 0.100 Inch Instead Of The 0.080 Inch Thickness, And This May Have Caused The Door Sag. I Am Using This With My Prusa I3 From Makerfarm. The Only Change I Made To Schlem'S Plans Was To Put The Filament Ingress On The Top, But That Was Mostly A Matter Of Preference. I'Ve Included Only The Door Hanger Stl And Freecad Source Rather Than Create Yet Another Copy - See Schlem'S Original And Link To Instructables For Complete Instructions And All Other Needed Parts.

Statistics

Category

Tags