Head tracker case. Arduino Nano 33 BLE
Description
Case for Arduino Nano 33 BLE headtracker Set button / reset hole/ USB / Power Immersion RC power connector 5Pin Used the NANO pin holes but cut the + pin to put a diode in between. Because of the multi pin connector also Reset pin/ +5V out and A1 are connected to it. No need to but was more stable. 3.5MM audio connector. Only soldered the tip and ground of the stereo connector but made a loose wire underneath just incase. Button 12x12mm tactile with LED. connected to the 3.3V output using a 47-86 Ohm resistor. (also depending on color)
Statistics
Likes
0
Downloads
0