Bambu X1 Calibration and Prime Strip Remover/Scraper
Description
I hate having to remove the build plate from the chamber just to scrape the calibration and prime strips from it, so I came up with this oddball little scraper that's just big enough for those two strips, also keeps finger prints off of your build plate and can save your fingernail beds. Lay it down flat against the plate at the beginning of the triangle part of the calibration strip, and slide it backwards, the strip will pop up in the slot. same with the purge/prime strip, just around a corner lol. This is the first thing I tried designing in Plasticity as well, so it's only been tested a few times. ideas for improvement are welcome!
Statistics
Likes
0
Downloads
1