Ambidextrous grip
Description
I needed an ambidextrous grip because in the competitions I do there are exercises to be done even with the weak hand, I also wanted to optimize the two-handed grip. This grip is perfect for my hands which are quite large. You will need a serrated washer or a groover washer to improve the tightness of the screw which otherwise has a tendency to loosen due to the elasticity of the material. Use a little sandpaper to fit the palm of your hand, especially where the two halves join. I scaled the design to 104% to compensate for shrinkage in cooling, but maybe 103% would work too. I set up a Testfit to be able to do some tests without wasting time and filament. Use the Brim with a good width (8/10 mm) and a little fixative on the plate, because the ASA with so much mass tends to warp. Use a strong glue between the two halves to avoid problem during live fire. NOT FOR COMMERCIAL USE!! - TESTED LIVE FIRE
Statistics
Likes
0
Downloads
0