G923 F1 Wheel for Sculpto 20cm round print bed and F1 logo
Description
I needed to modify the original version by pcrowlz (https://www.thingiverse.com/thing:5160274) because the frame was a bit too large for the Sculpto Pro 2 print bed (its circular!). 1) I needed to cut off the upper corners of the frame. I did not bother with extending the recesses and make new screw holes - I just used a screw at the the lower connectors, but only glued the upper where the screw hole had been removed. 2) To not look too goofy, I also made a new version of the upper handles pieces, so the extend over the part that was removed from the frame. 3) For the lower handle pieces and buttons, you should just use the ones from pcrowlz design: https://www.thingiverse.com/thing:5160274, or the remixed buttons from Holland37: https://www.thingiverse.com/thing:5569081. 4) I also added the Formula 1 logo to the center of the new frame. This use is an unofficial fan use, and is not associated in any way with the Formula 1 companies. F1 and related marks are trade marks of Formula One Licensing B.V. I am therefore not sharing the print file for the logo.
Statistics
Likes
0
Downloads
1