Magnetic Airtag Case
Description
Airtag case to hold both an airtag and magnet coaxially. It's designed for a 1" diameter magnet with a countersunk hole through the center. The hole in the case isn't threaded, so use a self threading screw. A threaded cap holds the airtag on. The threads are large, so high resolution isn't needed (0.2" layers works fine). No supports are necessary depending on the orientation you print in. I've also included 2 sizes depending on the screw length you use. I'd recommend using PETG if you plan on using this in any automotive application. I used these magnets, and cut the screws down a bit: https://www.amazon.com/dp/B0CDR3VW7P
Statistics
Likes
0
Downloads
0