Cricut Pen Adapter - Crafter's square metallic marker
Description
Based on the collet adapter by Jordan Truesdell. This fits a Crafter's Choice (typ at Dollar Tree) metallic marker or any marker with an 11mm diameter. Because the marker has a short shoulder the collet adapter could not be changed to work using Jordan's excellent instructions so I just made a 14mm gauge. Set the gauge on the collet and insert the marker so that the tip of the marker just reaches the top of the gauge. That will position the marker tip the requisite 33mm from the tool holder shoulder. Remove the gauge and place the adapter int eh tool holder (existing pen adapter needs to be removed) NOTE: Because of variation in 3D prints I strongly suggest you first have the tip just a bit lower than the top of the gauge to avoid risk of damaging the marker tip. Make a test drawing and adjust as needed.
Statistics
Likes
0
Downloads
0