Ender 3 V2 Motherboard Case (External)
Description
Motherboard Case Designed to externalize the BTT_SKR_V3 board or the creality stock board 4.2.7 I designed this because I was getting tired of getting under my printer and risking knocking my leveling out of wack by either moving screws or bumping the gantry etc. This print requires (5) m3x5mm thread heat inserts - to fit the original 3mm socket head screws from creality (2) m3x8 heat insert - for lid (2-4) m3 hammer nuts (tnuts) (2-4) m3x10 bolts (2) m4 bolts to mount elbow to the back of the carriage 1.5ft length of pairs 16 gauge wire (power) extension for display adaptor NOTE: This solution by default does not allow for the stock power wire from the power block. you will have to replace this with a longer cord NOTE: the display cord is not long enough to reach the original position. you will either have to move the display to the left hand side or extend the display cable. This will fit either the BTT_SKR_V3.0 OR the stock creality board. The front panel will have to be cut out after print.
Statistics
Likes
0
Downloads
0