REFC Labs FiiO BTR7 Car Cupholder Dock
Description
This is a basic BTR7 Dock for your car's cupholder. It is designed to use minimal material, print quickly, and retain use of the cupholder for storage of small items. This was designed to fit a Chevy Silverado but should fit other car cupholders 82mm or less. Once printed, install your BTR7, plug the USBC cable in from below, then hot-glue the cable in place. Bring up and around through the notch in the dock. Done! Set your BTR7 in "car" mode, and leave the usb cable plugged into your car's power source. Every time you dock your BTR7, it will power on and connect on its own. Print with at least 3 walls. Low (20-25%) infill is fine, since this is design is nearly all wall structure. No brim or raft needed as the base is purposefully flat without chamfer or filet.
Statistics
Likes
0
Downloads
0