Sink Tailpiece Screw & 5/8 Hose Adapter
Description
I'm doing a Sprinter van conversion and ran out of room under the sink. A standard tailpiece was too long - I couldn't remove my gray water jug. These parts solve my problem by reducing the minimum depth and decreasing the part count. The "Cap Tight" is to spec and works really well on my Bambu X1. My old printer would have needed the "Cap Loose" version (with the threads backed off 0.01 inch) to make it screw on. The drain-to-hose adapters fit in a 5/8 inch ID hose (3/4 hose, generally). One is 45 degrees to help with the tight clearance. The other is 60 degrees which helps a little more. The 60 degree is also offset to help speed draining in the northern hemisphere (where drains swirl clockwise). If you're in the southern hemisphere, flip the pattern before slicing.
Statistics
Likes
0
Downloads
0