Peppy
Description
PROPERTY OF HOYOVERSE. USED WITHOUT PERMISSION. i'm not sure i released Peppy anywhere since i made him a while ago... but here he is. this was one of my first resin prints but required few improvements. you can print him with no accessories or unhide the harness and/or jet pack in BLEND. objects in BLEND are set to 4xSS since its such a simple model. the few modifications i made were, extending left paw closer to the ground with proportional editing and smoothing his snout just a bit. his tongue was also thickened for easier printing. he should be printable in FDM but RESIN is obviously preferred. actually, you might want to thicken the tongue just a bit more if you're printing FDM or just print bigger. don't forget to hollow your STL in PrusaSlicer, and add a few holes (1.0 - 1.3mm diameter) to relieve the pressure. enjoy! this print is just under 10cm tall, so even old resin printers with smaller build volumes should have no problem printing him. let's see some prints!
Statistics
Likes
0
Downloads
0