Teenage Engineering EP–133 K.O. II Protective Cover
Description
I wanted a cover/crush protector for the EP-133 so I can throw it in a bag for travel. I grabbed the official bag from TE, but it's a soft bag, so I made a cover to go along with that bag. The initial concept was a basic printed shell, but realized if I wanted to keep the profile as low as possible, the center of the shell could flex enough to contact the fader and pots, so I added pillars that register around the knobs and fader. It also occurred to me that 3D printed plastic rubbing against the surface of the device could scratch it up. My solution was to use my XL to mix PLA with TPU for the parts that actually make contact. It's just friction fit for now, but it works for my needs. There is an XL 3MF that I used to print my case. I figured since I was doing multi material, I might as well add some TE style graphics. There is also a 3MF for the MK4. The case should fit fine on a MK3/MK4 or X1/P1P/P1S build plate. No supports needed. I would recommend that if you print in only one hard material, you use as a deck saver only, as I cannot guarantee that it will not scratch up the surface of your EP-133. In the pictures is Prusament Galaxy Black and Galaxy Silver PLA, and the red is Overture TPU.
Statistics
Likes
0
Downloads
0