Motorola APX6000 Belt Clip
Description
The APX6000 is a radio commonly adopted in enterprise solutions and by emergency service organisations. It's useful to clip the radio to your belt and operate the radio via a wired microphone. We never seem to have enough belt clips for all our radios. Replacement belt clips are expensive, too. Here is my design for a belt clip that will do an effective job to secure the radio to your belt. The clip can be made in most plastics, though I would not recommend straight PLA due to it being brittle. I found PLA+ effective as it gives a bit. Note that all types of PLA don't like being left in the sun, so if that could be a problem, go for PETG or a stronger plastic. My print is made in 1.75mm eSUN PETG Black filament, with 0.2mm layer height and 25% infill on a Bambu Lab X1 Carbon printer. Print supports are required. I hope that you can find this print useful, too. Remember to leave me some feedback or even a tip to keep me enthused to make more of these drawings. For my latest models, see my main uploads site: https://makerworld.com/en/u/3687936443
Statistics
Likes
2
Downloads
2