Mop Head to Acme Broom Handle Adapter
Description
This is a remix, thank you to the original designer because I could not figure out how to design Acme threads in Fusion 360. I needed a new handle for my shop broom. I had an old mop handle that used a spring clamp design to hold a disposable cotton mop head. After removing the clamp I had a nice, long handle with two holes ready to accept an adapter. The through bolts are M6x50mm but 45mm bolts might work. I printed the threads at 100% infill for strength and the rest of the body at 25%. Sliced using PrusaSlicer and printed out of HT-PLA+. So far it has held up fine. I have included my config file for PrusaSlicer. Print the big end on the build plate, you should not need any supports.
Statistics
Likes
0
Downloads
0