CREALITY K1 and K1C LID RISER

Description

/////ATTENTION Depending on whether you're printing in PLA or ABS, use the STL files for the corners labeled PLA or ABS. All the parts are the same except for the corners. In the ABS version, the walls are 0.75mm wider due to material shrinkage when cooling. This difference ensures there are no gaps between the pieces. However, if you encounter any fit issues, I've included STEP files so you can adjust the corners to better suit your printer. *In the images, you can see the orientation I used for printing each piece. The bump can be printed in two ways. I chose to print it upright to match the lines with the rest of the pieces. It's a matter of preference and aesthetics. /////BOM to print: 1 x LID_RISER_K1C_BACK_VENT_ABS_PLA 1 x LID_RISER_K1C_BACK_WALL_ABS_PLA 1 x LID_RISER_K1C_BUMP_ABS_PLA 1 x LID_RISER_K1C_BUMP_VENT_ABS_PLA 1 x LID_RISER_K1C_BUMP_WALL_ABS_PLA 4 x LID_RISER_K1C_HANDLE_ABS_PLA 2 x LID_RISER_K1C_NORMAL_VENT_ABS_PLA 2 x LID_RISER_K1C_NORMAL_WALL_ABS_PLA /////ABS version 1 x LID_RISER_K1C_BUMP_CORNER_ABS 3 x LID_RISER_K1C_CORNER_ABS /////PLA version 1 x LID_RISER_K1C_BUMP_CORNER_PLA 3 x LID_RISER_K1C_CORNER_PLA /////ABS OPTION I used the preset settings for ABS in OrcaSlicer to print. The extruder and bed temperatures depend on the type of filament being used *I'd recommend preheating the chamber to at least 40ºC before starting the print. Only activate the chamber fan after it reaches 50ºC. /////EXTERNAL WALLS Outer brim only: Brim width: 5 mm Brim-object gap: 0 mm Supports: only on the Back Wall, at the tube entrance Seam position: Back /////VENTS and HANDLES Outer brim only: Brim width: 1 mm Brim-object gap: 1 mm Supports: N.A. Seam position: Back /////CORNERS Outer brim only: Brim width: 5 mm Brim-object gap: 0 mm Supports: N.A. Seam position: Back /////BUMP Outer brim only: Brim width: 5 mm Brim-object gap: 0 mm Supports: YES Seam position: Back

Statistics

Category

Tags