Moen faucet cartridge pulling tool
Description
This is a simple tool that helped me pull a stuck Moen faucet cartridge. I think it should work for just about any Moen single cartridge faucet but I specifically used it to replace a 1225 cartridge. Print it in the strongest material you have and consider adding additional perimeters and upper/lower surfaces so it does not break. To use it you will need some washers or nuts that are larger than the thread of the screw that holds the cartridge in. Place the washers on top of the 3d printed part and stick the screw through the hole. The 3d printed part will butt up against the tube that the cartridge is in and as you tighten down the screw it should pull the cartridge out.
Statistics
Likes
0
Downloads
0