Mazzer Major Single dose hopper & microswitch override
Description
This is a variation on the previous design https://www.thingiverse.com/thing:6594617 This adaptor plugs directly into the grinder without the collar. Bellows used are same as the previous drawing. However, without the collar, the microswitch in the Mazzer will not be activated, causing the grinder not to run. To remedy small printed block can be used to permanently keep the microswitch activated, I have used some electrical tape to hold the block in place. This collarless design has less air leak compared to the previous design with the collar, as seen by the higher air pressure felt at the chute when the bellows are depressed.
Statistics
Likes
0
Downloads
0