omp m2 evo
Description
Differences of the remix compared to the original slightly changed for M2 Evo It is best to print it nose up and using ‘Tree’ supports in Cura. I also add 2 extra manual supports on the right hand side in the Cura preview screenshot to give it a little more support while printing as seen in the Cura preview picture. I also enable brim to help a little more. I use 0.2 layer height with ‘Use Adaptive Layers Maximum Variation' set to 0.05 and 'Adaptive Layers Variation Step Size' set to 0.025. This allows curves to look better with a variation of layer height from 0.15 to 0.25 and still not slow the print down too much. OrcaSlicer description: Main changes: nose-up to minimize supports; careful tree support painting; expanded default wall size to 0.6mm on an 0.4mm nozzle to make walls two layers rather than three, reducing printing time substantially
Statistics
Likes
0
Downloads
0