MDR/MDRX FE to SE Ejection Cover and Dust Cover V5
Description
This is an update to the MDRx Forward to Side Ejection Plate cover. This design removes the rear tail, improves the strength of the forward claw, improves the strength of the rear slider, uses a smaller and lighter spring for ease of install, Updated Spring Guide, Increased strength Switch, and improved dust cover retainer. In addition, there is a Blank side plate for anyone that would like a quick plate release on the SE MDR/MDRx Print: 1x Dust Cover Retainer 1x SE plate 1x Slider 1x Spring Guide 1x Switch Purchase: 1x 82 Degree Flat Head, Star Drive, #4-20 Thread Size, 1/2" Length Black Oxide Plastic Screw https://www.amazon.com/dp/B00GDYNQBM?psc=1&ref=ppx_yo2ov_dt_b_product_details 1x 5mm x .8mm x 20mm Spring https://www.amazon.com/dp/B0CGZP59TN?ref=ppx_yo2ov_dt_b_product_details&th=1 1x AR10 Dust Cover This has been tested with both the Guntec Dust Cover and Strike Industries dust covers https://www.opticsplanet.com/guntec-usa-ar-10-lr-308-ejection-port-dust-cover-assembly.html https://www.opticsplanet.com/strike-industries-ar308-enhanced-ultimate-dust-cover.html Assembly: 1. Gather above parts 2. Test fit Switch into Slider for fitment. If it doesn't fit sand the switch ears until it does. Usually this is the back side of the ears towards the rear of the slider 3. Insert Spring onto Spring Guide 4. Flip SE plate until you see the bottom side 5. Insert Spring and Spring guide into Slider, spring guide base away from slider 6. Insert Slider, Spring, and Spring Guide into SE Plate 7. Flip over the SE Plate and insert the switch into the recesses in the slider 8. Screw in Switch 9. Install Dust cover per dust cover instructions keep in mind which side you wish it to be on 10. Push Switch Forward and insert Dust Cover retainer. This is required if you use a standard dust cover with a rod. Note, you do not need the C Clip. The switch when released will retain dust cover retainer Installation: Push the Slider Switch Forward, install, and release. You may need to sand various parts for fitment. This is V5 of the Design. IPT's attached for modification. Drawings of the Spring and Fastener are attached for reference. Links for images/videos here https://imgur.com/a/byXnXiL
Statistics
Likes
0
Downloads
0