P90 AEG to Odin Airsoft Speedloader Adapter
Description
Adapter to connect CA/Marui/Krytac or other compatible Midcap AEG magazines to an Odin (or a clone) winding speedloader. Includes a stop ball to keep BB's from spilling out (it'll still drop ~1 ball, but that's better than 20!) Parts Needed: 1x M3x20 Socket Head Cap Screw 4x M3x10mm Flat Head Screws 2x 6mm Airsoft BB's 2x 1" Long, 0.24" OD, 0.2" ID Compression Springs (Ex. McMaster 1986K365 or 9657K298) Amazon Link for Springs: https://www.amazon.com/gp/product/B0BG82DWN4 Assembly Instructions: 1: Insert a 6mm BB into the hole on the narrow side of the adapter furthest from the BB feed path. This is your stop ball, it will protrude into the BB feed path slightly when a spring is behind it. 2: Follow up with one of the springs, then another BB. 3: Insert a suitably long tool to drive the BB/Spring/BB down until the BB in the back clears the screw hole in the long side of the adapter - you'll see the BB pass by. 4: Drive in the M3x20 screw until it touches your tool, and make sure the BB is ahead of it. This keeps the screw away from your spring. Remove the tool and continue driving the screw until hand tight. 5: Drive in 4x M3x10mm Flat Head screws to attach the Mag Face plate to the base as shown in the pictures. Do not use stronger springs in the stop ball hole. Too much force will make loading unpleasant. For printing, print the mag adapter face flat side down. The body can be printed with either flat face on the bed, but you'll get the best results printing as shown in the pictures.
Statistics
Likes
0
Downloads
1