Bird Buddy Accessory Extension
Description
A simple 6cm extension for Bird Buddy accessories. Attaches with an M5 screw and allows accessories to be added at an offset to the factory mount point. An M5x8x7 heat-inset threaded insert is required. A shorter one should probably be fine. I am using the ones from this set: https://www.amazon.com/Mardatt-Threaded-Embedment-Assortment-Printing/dp/B08ZHFLDNQ Depending on filament, the hole for the insert may be a bit small, so so material may have to be cut away (or pushed out with a screw) after insertion. I recommend printing in ASA for long-term stability, but PLA should be fine for quite a while. If this is useful for you, please consider buying me a coffee! https://ko-fi.com/grajohnt
Statistics
Likes
0
Downloads
0