ROBO R1 Dual Fan Duct Cooling System
Description
*Update* I Have Just Made A New Change To The Fan Duct So Than When Screwed Into Place They Sit Further From The Build Plate. I Noticed That The Corners Had A Possible Tendency To Touch The Plate. May Need Some Filing To Fit. Part Cooling Upgrading For Printing Better Bridges And Overhangs. This Is A Remix Of The Techsupportgo'S Mount With Some Minor Changes To The Design, And To The Print Itself. The Rear Shroud Has Been Cut Shorter So That None Of The Plastic Comes Into Contact With The Heater Block. (On My Printer It Is The Front Shroud, Because Of How It Have It Setup...) As A Result Your Part Is Not Slowly Destroying Itself By Melting On The Heater Block As You Print, Especially With High Temp Filaments. See Instructions For Printing Recommendations And Hardware List.
Statistics
Likes
17
Downloads
0